7
BEFORE LEAVING
When the installation is complete, always check for gas leaks using a soapy solution. Never use a flame to
make this check.
Ignite all burners on high flame to ensure correct operation of gas valves, burners and ignition. Turn gas taps
to low flame position and observe each burner to ensure they ignite completely at all ports and that the flame
is stable. Conduct these checks for each burner individually and concurrently.
When satisfied with the hotplate, please instruct the user on the correct method of operation. In case the
appliance fails to operate correctly after all checks have been carried out, please call the Bertazzoni Service
Centre.
USER INSTRUCTIONS
WARNINGS:
Keeping appliance area clear and free from combustible materials, gasoline and other flammable
vapors and liquid.
Do not store dangerous or flammable material in the cabinet areas above appliance; store them
in a safe place in order to avoid potential hazards.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
DO NOT STORE OR USE FLAMMABLE LIQUIDS OR ITEMS IN THE VICINITY OF THIS APPLIANCE.
DO NOT MODIFY THIS APPLIANCE.
WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT SHALL NOT
BE
USED AS A SPACE HEATER.
WARNING: SERVICING SHOULD BE CARRIED OUT ONLY BY AUTHORISED PERSONNEL.
For description of hotplates refer to installation instructions.
Using burners
A diagram is etched on the control panel above each knob which indicates which burner corresponds to that
knob.
Manual ignition:
Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure.
Turn the knob that corresponds to the burner selected counterclockwise to the MAXIMUM position at the
etched star (large flame) and place a lit match up to the burner.
Burners fitted with a safety device (thermocouple):
Turn the knob that corresponds to the burner selected counterclockwise to the MAXIMUM position at the
etched star (large flame) and then press the knob down to activate the spark ignition. Once ignited, keep
pressing the knob for about 10 seconds to allow the flame to heat the thermocouple. If the burner does not
remain alight after releasing the knob repeat the above procedure.
If the flame does not light after the first attempt, wait 5 minutes for the gas to dissipate before attempting to
re-light the burner.
Note:
Dual burner is composed by two burner (inside and outside); each one operates under the relative gas
valve independently from the other one.
Note: It is recommended not to try to ignite the burner if the relative flame cap is not in the correct position
(20 strony)
(48 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji